Pool wall cross-section with extra isolation in the rib section

Pool wall cross-section with extra isolation in the rib section

Pool wall cross-section with standard isolation in the rib section

Pool wall cross-section with standard isolation in the rib section

Filter bay, fits for each pool type

Filter bay, fits for each pool type

Technology

Source materials

Our swimming pools "PolyPool" are made of isopthal acid - neopentyl glycol - polyester with glass fiber reinforcements.

Structure

For the production of our pools there are only used resins and glass fiber materials that were developed for pool construction.

Production

All our pools are produced hand-laminated. This garantees the obervation of our precise component quality. Throughout the whole production process the components are quality-assured multiple times. 40 years of manufacturing experience garantee an absolute high quality product with best characteristics.

Finish

The integraded stairs of our pools are equiped with anti-slip surface. All our pools have an edge region of about 15 cm. Large radiuses in the corners allow a favourable flow and easy cleaning of the pool. To increase bump stability, there are reinforcing ribs laminated on the outside of the pool.

Installation (quick overview)

  • Dig excavation
  • Build reinforced concrete bottom
  • Cover with hard-wearing polystyrene foam boards (2cm)
  • Pool is placed on top of the bottom
  • Installation parts are installed
  • Filter cycle is tubed
  • Pool is filled with about 40cm of water; leakless water circulation is checked
  • Pool is backfilled with concrete; this should be done in stages; water level in the pool should always be min. 30cm higher than backfill.

Care

At the beginning of the season or during the summer, the high-quality surface of our pools always allows easy cleaning.

Insulation

On request (with extra charge) our pools can be equipped with extra foam insulation that is about 50 to 70 mm thick. At installation time, when professionally backfilling the pool, the extra foam installation serves as protection and extra insulation.

Insulation

Extra insulation

Stability

Our swimming pools are manufactured with many reinforcement ribs, edge and bottom reinforcement, and step stabilizers and therefore have very high stability. During transport the pool is protected against vibration, and when lifting the pool, the stability is increased by two extra beams (100 x 150mm) on the outside. By this means our pools have perfect stability, also when backfilling the pool.

Stability

Stability

Stability

Stability

Filter bay

see extra page "Filter bay"